Temperature Unit Setting; Battery Replacement - TFA 35.1142 Instrucciones De Uso

TFA_No. 35.1142_Anleitung_04_17
VIEW - Wireless weather station
• The maximum and minimum values are automatically reset at midnight.
• To clear the recorded maximum or minimum readings manually, press and hold the MAX / MIN
button for two seconds while the maximum or minimum values are displayed.

7.4.2 Temperature unit setting

• Press the +|°C °F button in normal mode to change between °C (Celsius) or °F (Fahrenheit) as tem-
perature unit.
7.4.3 Trend arrows
• The trend arrows indicate whether the values for temperature and humidity are currently increasing,
steady or decreasing.
7.5 Display of seconds or day-of-the-week
• Press and hold the +|°C °F button in normal mode for three seconds to change between seconds or
day-of-the-week.
8. Positioning and mounting of the base station and transmitters
• When placed outdoors, choose a shady and dry place for the transmitter(s). Direct sunlight may
trigger incorrect measurement and continuous humidity damages the electronic components need-
lessly.
• Place the base station in the living room. Avoid the vicinity of any source of interference such as
computer screens, TV sets or solid metal objects.
• Once the desired location is chosen, check if the transmission from transmitters to the base station
is possible (transmission range of up to 60 m in open areas). Within solid walls, especially with
metal parts, the transmission range can be reduced considerably.
32
05.04.2017 14:58 Uhr Seite 17
VIEW - Wireless weather station
• If necessary choose another position for the transmitter(s) and/or base station.
• Is the transmission successfully, you can wall mount the transmitters or place them onto a flat sur-
face.
9. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• Remove the batteries from all instruments if you do not use the products for a long period of time.
• Keep the devices in a dry place.

9.1 Battery replacement

• When the battery symbol appears on a channel display, change the batteries of the respective trans-
mitter.
• Change the batteries of the base station, when the battery symbol appears on the display of the
indoor values.
• Please note: When the batteries are changed, the contact between the transmitter and the base sta-
tion must be restored – so always insert new batteries into all devices or start a manual transmitter
search.
10. Troubleshooting
Problem Solution
➜ Ensure the batteries' polarity are correct
No display
➜ Change the batteries
33