Makita DML805 Manual De Instrucciones página 5

ASSEMBLY
CAUTION:
• Always be sure that the luminaire is switched off,
unplugged, and the battery cartridge is removed before
carrying out any work on the luminaire.
Assembling the frame and the base (Fig. 1)
Assemble the worklight as follows:
1. Remove the screws.
2. Insert the legs of the frame into the base.
3. Align the holes of the frame and the base.
4. Tighten them with screws.
FUNCTIONAL DESCRIPTION
CAUTION:
• Always be sure that the luminaire is switched off,
unplugged, and the battery cartridge is removed before
adjusting or checking function on the luminaire.
Use with battery:
Installing or removing battery cartridge
CAUTION:
• Always switch off the luminaire and unplug before
installing or removing of the battery cartridge.
• Hold the luminaire and the battery cartridge firmly
when installing or removing battery cartridge.
Failure to hold the luminaire and the battery cartridge
firmly may cause them to slip off your hands and result
in damage to the luminaire and battery cartridge and a
personal injury.
To install the battery cartridge, release the cover lock, and
open the battery cover. And insert the battery cartridge.
Align the tongue on the battery cartridge with the groove
in the housing and slip it into place. Insert it all the way
until it locks in place with a little click. Then close the
battery cover. (Fig. 2)
To remove the battery cartridge, slide it from the luminaire
while sliding the button on the front of the cartridge.
CAUTION:
• Always install the battery cartridge fully in place. If not, it
may accidentally fall out of the luminaire, causing injury
to you or someone around you.
• Do not install the battery cartridge forcibly. If the
cartridge does not slide in easily, it is not being inserted
correctly.
Indicating the remaining battery capacity (Fig. 3)
(Only for battery cartridges with "B" at the end of the
model number.)
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light
up for few seconds.
Indicator lamps
Off
Lighted Blinking
NOTE:
• Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
Use with AC power:
Connect the plug to a power supply. (Fig. 4)
Turning on LED light (Fig. 5)
Press the switch once, the light shines brightly (high
mode). Press the switch again, the light shines mildly
(low mode). To turn off the light, press the switch once
again.
Battery protection system (Fig.6)
The luminaire is equipped with a battery protection
system to extend battery life.
When the battery becomes low, the LED lights go out
except one LED (the one on the second line center).
Then, after approximately five to ten minutes later, the
system automatically cuts off power.
OPERATION
CAUTION:
• Always put the luminaire on flat and stable place.
Otherwise a falling accident may occur.
Adjusting the angle of the worklight (Fig. 7)
Loosen the knobs on the both side. Adjust the angle of
the worklight. Then tighten the knobs again.
Using with tripod or vise (optional accessories)
(Fig. 8)
CAUTION:
• Read carefully the
accessories before using them with the luminarie.
• When using with tripod or vise, do not let the total
height exceed 1.75 m.
You can put the luminarie on the tripod or vise to facilitate
the operation.
Remaining capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the battery.
The battery may have
malfunctioned.
instruction manuals of the
5