Publicidad
Idiomas disponibles
Idiomas disponibles
J
K
L
M
7. Installation Tips
WARNING
» Failure to install the product as
instructed may result in damage to the
product and or may expose the user to
the risk of fire, electric shock, or serious
injury�
» This product should be installed and
maintained only by an experienced adult�
If in doubt, consult a professional�
» Before mounting, determine the suitable
mounting location� The product must be
fixed to a wooden or masonry/concrete
wall using fasteners that are appropriate
for the mounting surface�
» Do not install on drywalls, wall boards or
thin plywood� The mounting surface must
be capable of supporting the weight of
the product�
» For best results, install the product out of
direct sunlight�
» To avoid reconstruction install the product
in a proximity of properly grounded
socket outlet�
» Do not drill into any pipes or power lines
beneath the surface during mounting
holes preparation� Use voltage/metal
detector�
» The wall mounting bracket (H) is attached
to the product when delivered� Remove it
before installation�
For recessed installation B: The socket
outlet must be wired to an accessible 16 A
N
double pole switch in order to safely switch
the product on/off�
O
8. Operation
8.1
P
1� Connect the power cord with plug (G) to
a suitable socket outlet�
2� Set the power switch (F) to 'I' (product
Q
on)� The product beeps and U1�2 shows
on display (D)� The product is now in
standby mode�
3� Press the standby button (Q) to switch on
the product�
NOTICE
approximately 7 seconds after no other
button is pressed�
4� To switch off the product, press the
standby button (Q) again�
NOTICE
» Pressing any button on the remote or
touch controls (E) once, displays the
current room temperature� To select
any function, press the same button
twice�
» There may be a trace of odor during
the first few minutes of use, or after a
period of storage� This is normal and
quickly disappears�
» If the product is not in use for a long
period:
For wall installation A: Set the power
switch (F) to '0' and remove the plug (G)
from the socket outlet�
For recessed installation B: Set the wall
switch to off�
8.2
» Press the temperature button (L)
repeatedly until the desired temperature
has been selected�
Switching on/off
The display goes off
Setting temperature
EN
11
Publicidad
