Publicidad
Idiomas disponibles
Idiomas disponibles
• When the timer finishes, the buzzer will ring 3 times, and the screen will display End.
5.
SPEEDY COOKING
• By pressing START/Enter/Add 30 Sec., microwave will cook at 100% power for 30 seconds. Repeatedly
pressing START/Enter/Add 30 Sec while cooking or defrosting will add 30 seconds to cook time. The
maximum cooking time is 99 minutes and 99 seconds.
6.
WEIGHT DEFROST FUNCTION
• Press Weight Defrost once, the screen will display 0.0 and the lbs.
• Press numerical buttons to input weight to be defrosted. Input the weight ranged between 0.3~6.3lbs. If
the weight input is not within 0.3~6.3, the input will be invalid.
• Press START/Enter/Add 30 Sec. to start defrosting.
7.
TIME DEFROST FUNCTION
• Press Time Defrost once, screen will display 00:00.
• Press number pads to input defrosting time.
• Press START/Enter/Add 30 Sec. to start defrosting.
8.
AUTO MENU
• In unit waiting state, press Popcorn, Dinner Plate, Pizza Reheat, Frozen Entree, Beverage, Soup, Fresh
Vegetable, Frozen Vegetable or Potato to choose the auto menu.
• Press the same pad repeatedly to choose the weight of the food.
• Press START/Enter/Add 30 Sec. to start cooking.
9.
SENSOR COOK
• In waiting state, press Dinner Plate, Fresh Vegetable or Frozen Vegetable, the screen will display SC.
• Press START/Enter/Add 30 Sec. to start sensor cooking. SC will flash in the display.
• The sensor will sound once when steam is detected.
10.
MEMORY FUNCTION
• Press Favorite to choose memorized procedure 1-3. The screen will display 1,2,3.
• If the memory has been set, press START/Enter/Add 30 Sec. to activate. If it has not been set, continue
to procedure set . Only one or two stage procedures can be set.
• Example: to set the following procedure in memory slot 2 for cooking food at 80% power for 3 minutes
and 20 seconds.
• The steps are as follow:
1. In unit waiting state, press Favorite twice, until screen displays 2.
2. Press COOK TIME once, then press 3, 2, 0 in sequence.
3. Press POWER LEVEL once, PL10 displays, then press 8 and PL8 displays for 80% power.
4. Press Favorite to save the setting. Unit will beep, and return to waiting state. If you press
START/Enter/Add 30 Sec. again, the procedure will be saved in memory slot 2, and can be
activated from there.
5. Loss of power to unit will reset memory.
6. When you want to run the saved procedure, in unit waiting state, press Favorite twice, screen
10
Publicidad
