ELECTRONIC BATHROOM SCALE
PRODUCT USAGE
Before first use, the scales must be charged
for at least one hour before they can be
switched on for the first time�
Charging
• To charge the scales, plug the supplied
cable (to be used with a USB charger, not
supplied) into the connector on the side
of your scales� The following display will
appear:
During charging, the display flashes with the
number of bars proportional to the current
charge level:
• Once the battery is fully charged (after
approximately 2 hours), the display turns
off�
• Once charging is complete, unplug the
charger� Leaving the product charging for
too long is not recommended as this may
damage the battery�
Measurement unit
The default measurement unit is "Kilogram"�
To select the desired unit (kg, or lb), briefly
press the button next to the connector un-
til the desired unit appears� The unit is then
selected�
Operation
EN
Warning indicators
PROTECT THE ENVIRONMENT
GUARANTEE
This product is guaranteed against defects
in materials or manufacturing� During the
guarantee period, any such defects will be
repaired free of charge (proof of purchase
must be shown in the case of a complaint
under guarantee)� The guarantee does not
cover damage resulting from improper use
or negligence� In the event of a claim, first
contact the shop where you purchased the
product�
Autostop
3
Overload: remove weight immediately�
Battery low, charge scales�
After life, dispose of this product at a
designated waste recycling point�
7