Publicidad
Idiomas disponibles
Idiomas disponibles
6
6
GETTING STARTED
I
O
I I
Charging Unit Prior to First Use
I
Charge Unit For 24 Hours Prior To First Use. A user supplied USB charger with the following specifications is required to charge this
product: USB Type-A, Rated Output: 5.0 VDC, 1.0 A. Plug the USB charger into a wall outlet and connect the charging cable to the
unit. Make sure you slide the switch into the OFF (0) position before charging. The unit will not charge if the switch is in the ON (I)
position. See "Cleaning and Troubleshooting Your Waterpik® Water Flosser" for guidance on how to look after your battery.
Filling the Reservoir
Disconnect charging cable from the unit prior to filling the reservoir and product use. Lift flip top on reservoir and fill the reservoir
Fill
with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. The colored ring will be flush with the end of the knob if
Insert
the tip is correctly locked into place.
Eject
To remove the tip from the handle, press the tip eject button and pull tip from the handle.
CAUTION: Do not press tip eject button while unit is running.
Adjusting the Pressure Setting
I
You can adjust the pressure setting on your Water Flosser by simply sliding the pressure switch on the handle.
O
I I
I
Pressure
Setting
Recommended Technique
Lean low over sink and place the tip in mouth. Aim the tip toward teeth, and turn the unit ON (|).
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefly between teeth.
Continue until you have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly close lips to avoid splashing but allow water to flow freely from
mouth into the sink. Keep unit upright during use for best results.
When Finished
Turn the unit OFF (0). Empty any liquid left in the reservoir.
2.
If desired, the reservoir may be removed from the power handle by pulling the reservoir release latch while sliding the reservoir down
towards the base of the unit.
To replace the reservoir on the power handle, simply slide it up towards the top of the unit. The reservoir will snap into place when
1.
fully engaged.
Remove
7
7
Publicidad
