Publicidad
Idiomas disponibles
Idiomas disponibles
Meaning of light signals
Troubleshooting
Problem
The machine does not switch
on.
The coffee does not flow out
of the machine immediately
when I press the button.
The brewing time is longer
than before.
10 Press the flashing button to start the flushing cycle. The ristretto button is
on and the lungo button flashes during the flushing phase
Note: The water tank will be emptied without interruption. The flushing
cycle lasts about 3 minutes.
11 When the flushing cycle has finished, the ristretto and lungo button flash
a few times.
Note: It is normal that some water remains behind in the water tank after
the descaling procedure.
The machine switches off. The descaling procedure is finished.
- The selected coffee button flashes slowly: the machine is preparing your
drink.
- The selected coffee button flashes quickly: the water tank is empty, fill
the water tank with tap water.
- The selected coffee button flashes intermittently: The new coffee
quantity is saved and programming is active.
- The ristretto and lungo button flash simultaneously after brewing coffee:
you need to descale the machine.
- All three buttons flash simultaneously: the machine needs to cool down.
Wait approx. 2 minutes before you start brewing a new drink.
This chapter summarizes the most common problems you could encounter
with your machine. If you are unable to solve the problem with the
information below, visit www.lorbarista.com/support for a list of frequently
asked questions or contact the Consumer Care Center in your country.
Possible cause
The machine is not connected to
the mains.
The machine needs a few seconds
to heat up before it starts brewing.
The machine is clogging up with
scale.
English
Solution
Put the plug in an earthed wall
socket.
This is normal.
Descale the machine.
21
Publicidad
