FLEXIDOME IP 3000i/4000i/5000i (IR) outdoor |
FLEXIDOME IP starlight 5000i (IR) outdoor
Safety information
Read, follow, and retain for future reference all of the following safety
instructions. Follow all warnings before operating the device.
Safety precautions
Caution!
Installation should only be performed by qualified service personnel in
!
accordance with the National Electrical Code (NEC 800 CEC Section 60)
or applicable local codes.
Important safety instructions
–
To clean the device, do not use liquid cleaners or aerosol cleaners.
–
Do not install the device near any heat sources such as radiators, heaters,
stoves, or other equipment (including amplifiers) that produce heat.
–
Do not spill liquids on the device before installation is completed.
–
Take precautions to protect the device from power and lightning surges.
–
If powered by a power adapter, the adapter should be properly grounded.
The power cord must be connected to a socket or outlet with a ground
connection.
–
Use green/yellow (green with yellow stripe) ground wires.
–
Adjust only those controls specified in the operating instructions.
–
Operate the device only from the type of power source indicated on the
label.
–
Unless qualified, do not attempt to service a damaged device yourself. Refer
all servicing to qualified service personnel.
–
Install in accordance with the manufacturer's instructions in accordance with
applicable local codes.
–
Use only attachments/accessories specified by the manufacturer.
–
Protect all connection cables from possible damage, particularly at
connection points.
Caution!
!
The Low Voltage power supply unit must comply with EN/UL 62368-1. The
power supply must be a SELV-LPS unit and Class II for 12 VDC / 24 VAC.
Bosch Security Systems B.V.
| en
| en
| en
Safety information | en
2024-03 | 06 | F.01U.415.255
3