Fenix 602315 Instrucciones página 14

ENGLISH
S T
I
H
J
4. HOW TO USE
1. Place the lift ing tower over a fi rm and fl at
surface on its working place.
2. Remove the outriggers (H) from their
transport supports (C) by releasing the plas-
tic knob (V) and pull the outrigger (H) up.
Insert them into their working position (G)
checking that they are fi xed by the safety pins
(K). Th e longest outriggers must be placed at
the front, under the load.
3. Remove the pin (L) from the transport
plate (F) and remove the forklift (E). Turn
the winch handle (B) until the carriage (X)
has raised enough that it does not touch the
transport plate (F). Put the forklift s (E) in
horizontal position and secure them with the
pin (L).
4. Insert the outriggers (H) into their wor-
king position (G) checking that they are fi xed
by the safety pins (K). Th e longest outriggers
must be placed at the front, under the load.
5. Adjust the lift ing tower using the support
plates (J) by turning the crank (I) of the re-
gulating rod until it is level, checking the sta-
bilizing bubble level (Y) located at the base.
6. Put the load as close to the lift ing tower as
possible. Do not unnecessarily separate the
sound system from the lift ing tower body to
avoid overloading. See fi g. 2 (page 17). Fo-
llow loading instructions. See fi g. 3 (page 17).
14 14
M
A
U
E
L
X
K
F
G
B
C
V
Y
7. Elevation: To lift the profi les, a specifi c or-
der must be followed. Th e fi rst profi le to be
raised will always be the one located furthest
from the winch. Release the safety pin (A) in
open position (T) and turn the winch handle
(B) clockwise, lift ing the load until the desi-
red height. Immediately aft erwards, close the
safety pin (A) in position (S), until the end of
the section has been reached. Go on succes-
sively to the diff erent positions of each of the
profi les, until the desired height is reached. In
case the pin is hard to pull out, a small num-
ber of movements should be made with the
winch until founding the right position whe-
re the pin is released and can be pulled out
comfortably. Under no circumstances any of
the pins should be pulled with force. In case
of the lift ing tower does not need to be raised
to its maximum height, it is recommended to
raise all the profi les proportionally according
to the height, and not only one of them.
8. When using the lift ing tower outdoors, the
risk of wind is prevalent, for which there are
two fi xing side rings (M) in the upper part
of the second profi le, where safety cables
must be attached and fi xed on a secure and
fi rm surface (never on a vehicle or anything
that can move). When wind speed exceeds
30km/h, it is mandatory to bring down the
lift ing tower.
9