Lionelo Lavender i-Size Manual De Usuario página 15

10. Place your child in the seat and adjust the headrest (see: Headrest adjustment).
11. Fasten the seat belts (see: Fastening and unfastening the child in the seat).
FORWARD-FACING (100 - 150 CM)
1. Retract the Top Tether belt (see: Retracting the Top Tether belt).
2. Retract the seat belts (see: Retracting the 5-point seat belts).
3. Place the seat on the vehicle's seat in the position designated for installation.
4. Adjust the tilt of the seat in the sitting position (see: Seat tilt adjustment).
Note! If installing without ISOFIX system, skip steps 5 to 7.
5. Push the ISOFIX lever (14, fig. B) and the ISOFIX arms extend automatically (fig.
1). Anchor the ISOFIX arms in the attachments located in the car seat. The arms
will interlock and you will hear a characteristic click (fig. 2).
6. The green indicator on the ISOFIX button must be visible on both sides (fig. 3).
7. Push the ISOFIX lever (14, fig. A) and press the seat against the backrest of the
car seat. Push the base with a left-right movement towards the backrest to make
sure it is pushed as tight as possible against the car seat.
8. Place your child in the seat and adjust the headrest (see: Headrest adjustment).
9. Remove the car seat belt.
10. Guide the shoulder belt through the shoulder belt guide, which is located at the
bottom of the seat headrest (A, fig. 8). Guide the lap belt through the lap belt
guide (B, fig. 8).
11. Fasten the seat belt. You will hear a characteristic click.
12. Make sure the belts are not twisted.
13. Make sure the belts are correctly positioned in the guides and tightened, and
that the buckle is not too close to the lap belt guide (fig. 8).
FASTENING AND UNFASTENING THE SEAT BELTS
1. Loosen the seat belts by pressing the tension adjustment button (4, fig. B) and
pulling the seat belts (fig. 9).
2. Unbuckle the belts by pressing the red button on the buckle (fig. 10).
3. Put your child in the seat.
4. Adjust the headrest (see: Headrest adjustment).
5. Connect the belt connectors (fig. 11) and then insert them into the buckle. You
will hear a characteristic click. The seat belts are now fastened.
6. To tighten the belts, pull the belt tension adjustment strap (fig. 12). To loosen the
‑ 15 ‑ EN