Lionelo Lavender i-Size Manual De Usuario página 16

Idiomas disponibles

belts, press the belt adjustment button and pull on the shoulder belts.

Note! Make sure the seat belts are taut, close to the child's body and not twisted. Make

sure the lap belts run low and protect the child's pelvis. The belts should be tight against

the child's body, but should not be too tight and cause discomfort.

Note! Children under 87 cm in height may only use the seat with a reduction pad.

HEADREST ADJUSTMENT

To change the height of the headrest:

Unbuckle and loosen the seat belts by holding down the seat belt tension

adjustment button (4, fig. B). This will allow you to adjust the height of the

headrest more freely.

Pull the headrest adjustment lever (fig. 13).

The shoulder belt height setting is integrated into the headrest height setting. By adjusting

the height of the headrest, the height of the shoulder belts will be set automatically.

Note! The headrest should be adjusted so that the shoulder belts are not too high, for

example at or above the ear line, nor too low, for example behind the child's back. The

shoulder belts should be at child's shoulder height (fig. 14).

RETRACTING THE TOP TETHER BELT

Unfasten and retract the Top Tether belt and place it, together with the length adjuster,

in the storage compartment located in the rear outer part of the seat (fig. 15).

RETRACTING 5-POINT SEAT BELTS

NOTE! The following information is valid for the 100 - 150 cm group.

Unbuckle the seat belts by pressing the red button on the buckle (fig. 10).

Remove the reduction pad (fig. 16) and take off the cover of the seat belt buckle

(fig. 17).

Unfasten the metal clasps on the upper part of the backrest cover and lift this

part upwards.

Pull the seat belt buckle through the corresponding hole in the seat cover (fig. 18)

and release the crotch belt by pulling the metal buckle through the hole in the seat.

Unfasten the metal clasps on the lower part of the backrest cover.

Connect the belt connectors and then insert them into the buckle (A, fig. 19).

You will hear a characteristic click.

Place the fastened seat belt buckle in the storage compartment located in the

‑ 16 ‑