Lionelo Luuk Fix i-Size Manual De Usuario página 9

INSTALLATION USING ISOFIX AND THE CAR BELTS
1.
Place the seat on the sofa of the car.
2.
Tilt the ISOFIX sliding lever and extend the ISOFIX arms (fig. 2a).
3.
Anchor the ISOFIX arms to the anchorages located in the car's sofa. The arms will
interlock and you will hear a characteristic click (fig. 2b).
4.
Use the plastic guides included in the set to facilitate assembly if required (3, fig. B).
Make sure the guides are in the correct position (fig. 2c).
5.
Push the seat with a left-right movement towards the backrest to make sure it is pressed
as firmly as possible against the car seat.
6.
The green indicator on the ISOFIX button must be visible on both sides (fig. 2b).
7.
Then follow the steps described in the subsection INSTALLATION WITH THE CAR BELTS.
SEAT REMOVAL
1.
Unbuckle the car belt and remove the lap belt from the lap belt guide (3, fig. B).
2.
To detach the ISOFIX arms, tilt the ISOFIX sliding lever (2, fig. B) on both sides, then slide
out and retract the ISOFIX arms (fig. 3). The indicator on the ISOFIX button will turn red.
CLEANING AND MAINTENANCE
• Minor dirt should be cleaned with a damp sponge and a mild detergent.
• The cover can be washed at a maximum temperature of 30°C. For this purpose, the cover
must be completely removed from the seat.
• Dryers should not be used when drying. The cover should not be exposed to sunlight for
drying. The plastic parts can be cleaned with a damp cloth and mild detergent.
• Note! Do not use strong detergents or bleaching agents.
The photos are for illustrative purposes only, the actual appearance of the products may
differ from those shown in the images.
‑ 9 ‑ EN