cecotec CONGA 999 MAP GENESIS Manual De Instrucciones página 31

ENGLISH
- To ensure perfect mopping right from the start, it is recommended to evenly dampen the
mop before fixing it in place. It is also recommended to wash the mop after every use.
- It is recommended to be present when the robot vacuum cleaner is scrubbing.
When the robot vacuums cleaner returns to the charging base, you must remove the mop.
-
Do not leave the robot vacuum cleaner charging with the mop assembled.
Back Home mode
Press the Back home button on the robot, vacuum cleaner, on the remote control, or on the app
(with a house icon) to send the robot to the charging base. The robot vacuum cleaner will stop
vacuuming until it reaches the base.
Manual mode
Select the manual cleaning option in the app or use the directional arrows on the remote
control to manually control your robot vacuum cleaner.
Power Level function
Select the power level on the remote control or on the app to control the robot vacuum
cleaner's suction power level during cleaning. There are four suction power levels: Off, light,
normal and strong.
Cleaning schedule
To make cleaning easier, the robot vacuum cleaner has a function that allows it to be
programmed daily from the app. According to the setting, the robot vacuum cleaner will
automatically start cleaning in the selected days at the desired time.
5. CLEANING AND MAINTENANCE
Dirt tank. Fig. 8
Lift the top cover of the robot vacuum cleaner and remove the dirt tank.
1.
2. Open the tank by unlocking the side flap and empty it.
3. Once you have finished, put the dirt tank back into the robot vacuum cleaner.
High-efficiency filter. Fig. 9
- The high-efficiency filter is designed with fibres that help trap dust particles, dust mites,
pollen... It is very important to periodically clean the filter, to prevent these particles
from building up in the filter, causing efficiency loss. It is convenient to carry out this
maintenance once a week.
- It is recommended to replace the high-efficiency filter with a new one without exceeding
160 cleaning hours.
60
CONGA 999 MAP GENESIS
Recommendation
You can remove dirt from the high-efficiency filter with a small brush or gently shake the filter
on a hard surface to remove the dust. The high-efficiency filter cannot be washed.
Primary mesh filter and sponge filter. Fig. 9
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot vacuum cleaner's motor and damage it.
Cleaning the fall-detection sensors. Fig. 10
Use a clean, dry, and soft cloth to wipe off any dust from the fall-detection sensors located on
the robot vacuum cleaner's lower part.
Warning
Do not apply cleaning products directly on the sensors.
Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
mouth and to thoroughly clean edges and corners. These brushes can wear out over time,
negatively affecting cleaning efficiency. For this reason, it is suggested to replace each side
brush after a maximum of 220 hours or less.
Recommendation
It is recommended to clean the side brushes once a week with the help of the self-cleaning
brush.
Sensors
- The robot vacuum cleaner has different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles or fall-detection sensors
that help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can deteriorate over time,
causing possible navigation errors.
- It is suggested to clean all the robot sensors with a dry and soft cloth after a maximum of
35 hours of operation or less.
ENGLISH
61
CONGA 999 MAP GENESIS