Publicidad
Idiomas disponibles
Idiomas disponibles
P
reparation Before Operation
Remote controller
Battery replacement indicator
Operation
display section
Temperature
buttons
Operation
select button
ECONO COOL
button
I-SAVE button
Clock button
Time, timer set buttons
Change the time forward/backward
(On timer) : The unit turns on at the set time.
(Off timer) : The unit turns off at the set time.
Press
(forward) and
of timer.
Weekly timer set buttons
Press
to enter the weekly timer setting mode.
Press
and
to select setting day and number.
Press
,
, and
to set on/off, time, and tempera-
ture.
Press
to complete and transmit the weekly timer setting.
Press
to turn the weekly timer on. (
Press
again to turn the weekly timer off. (
out.)
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
Off/On
(stop/operate) button
Fan speed control
button
Vane control button
Time, timer set
buttons
forward button
backward button
Weekly timer set
buttons
Reset button
Lid
Slide the lid down
to open the remote
controller. Slide it down
further to get to the
weekly timer buttons.
(backward) to set the time
lights.)
goes
Off/On (stop/operate) button
Operation select button
(Auto)
(Cool)
(Dry)
Temperature buttons
Fan speed control button
(Auto)
(Silent)
(Low)
(Medium)
Vane control button
Press
to select vertical airflow direction. Each
press will change airflow direction in the following
order:
(Auto)
(1)
(2)
• Two short beeps will be heard from the indoor unit when set to Auto.
• Moving the horizontal vane/multi-flow vane manually can cause
trouble.
• The horizontal vane/multi-flow vane automatically moves in certain
intervals to determine its position, and then it returns to the set posi-
tion.
• When the air outlet is switched between 1 flow and 2 flow, the hori-
zontal vanes may move and change their positions.
Vane control button
Press
to select the air outlet(s).
When 2 flow is selected, air blows from the top and
the front of the unit. When 1 flow is selected, air
blows only from the top of the unit.
(2 flow)
The multi-flow vane is automatically set to the appropriate position.
Even if 2 flow is selected, air will blow only from the top of the unit in
the following conditions:
• During cool mode/dry mode: The room temperature is close to set
temperature. The air conditioner has operated for 0.5 to 1 hour.
• During heat mode: The air flow temperature is low.
(During defrosting operation, start of operation, etc.)
ECONO COOL button
The set temperature and the airflow direction are automatically
changed by the microprocessor.
I-SAVE button
A simplified set back function enables to recall the preferred
(preset) setting with a single push of the
the button again and you can go back to the previous setting
in an instance.
(Heat)
(Fan)
(High) (Super High)
(3)
(4)
(Swing)
(1 flow)
button. Press
EN-5
EN
Publicidad
