ATOMSTACK B3 Instrucciones De Uso página 10

3.3 Alignment Calibration
3.3.1 Remove the dot card, fix the laser focus to 8mm, and
select "Absolute Coords"->"Home" for the coordinates.
3.3.3 Set the engraving parameters (refer to the laser's
parameter table) and set the Scale value according to
the desired positioning size, recommended input is 150.
3.3.2 Click on "Camera Control"->"Calibrate Camera Alignment"->"-
Camera"->"Next".
3.3.4 Check for any collisions while framing. If a collision occurs, adjust
the Scale value to a smaller one.
Scale
Scale
mm^2
100 200*200
300*300
150
200 400*400
08