Publicidad
Idiomas disponibles
Idiomas disponibles
2）In the case of engraving with LightBurn and wanting to open the box cover to observe the engraving, you can open the box cover to pause
the engraving machine, then click pause in LightBurn and after 5 seconds, click resume. The machine will continue engraving. Closing the box
cover will not affect the engraving process.
3) In the case of engraving with LaserGRBL and wanting to open the box cover to observe the engraving, you can open the box cover to pause
the engraving machine, then click the "
" in the bottom right corner of the software. The machine will continue engraving. Closing the box
cover will not affect the engraving process.
04
Publicidad
