ATOMSTACK B3 Instrucciones De Uso página 11

3.3.5 Click "Start" to make positioning marks.
3.3.7 Click on the cross points in the order of numbers 1-4.
First, enlarge the pattern at position 1 to the maximum and
double-click on the cross point. If there is an obvious offset in
the double-clicked cross, you can click on position 2 in the
image below or any blank position, and then reselect and
double-click on the cross point.
3.3.6 After engraving is complete, click on position 1 below to move the
laser to the upper position to avoid obstructing the engraved pattern. Click
on Capture Image at position 2, and then click on 3.
3.3.8 Click "Finish."
09