Miele Triflex HX1 Serie Instrucciones De Funcionamiento página 25

You will hear an operating noise, which
is a normal part of how the
ComfortClean function works.
 Twist the fine dust filter clockwise.
Use the recesses to help you (Fig.
35).
 Remove the fine dust filter (Fig. 35).

Risk of damage caused by
incorrect cleaning.
The fine dust filter can become
damaged and be less effective as a
result.
Do not clean the fine dust filter with
water and avoid cleaning the inside.
Do not use pointed or sharp-edged
objects to clean the filter. Do not
brush the fine dust filter.
 Hold the fine dust filter over a bin.
 Carefully knock the fine dust filter
with the rubberized lower edge.
 Turn the fine dust filter slightly while
you do this to free the dirt from all of
the crevices.

Risk of damage caused by
incorrect cleaning.
The pre-filter can become damaged
and be less effective as a result.
Do not clean the pre-filter with water.
Do not use pointed or sharp-edged
objects to clean the filter.
 Clean the pre-filter with the dusting
brush supplied or with a dry cloth.
 After cleaning the fine dust filter and
pre-filter, reinsert the former into the
latter by pressing the round cap on
top of the fine dust filter down as far
as it will go.
To continue achieving the best
possible cleaning results, replace the
fine dust filter (HX FSF-2) with a new
one after approx. 3 years.
 Reinsert the pre-filter in the dust
container (Fig. 36).
 To do this, line up the guides (arrows)
and turn the pre-filter back to its
original position (Fig. 37).
 Close the dust container flap, making
sure it clicks into place.
 Replace the dust container on the
PowerUnit connector.
Cleaning the dust container
Clean the dust container as required.
 Remove the dust container.
 Empty the dust container over a bin
and lift the pre-filter upward to
remove it (Fig. 34).
 Clean the dust container using water
and mild detergent.
 Dry the dust container carefully.
 Reinsert the pre-filter in the dust
container and turn the pre-filter back
to its original position (Figs. 36 + 37).
 Replace the dust container on the
PowerUnit connector.
Cleaning the Electrobrush (Fig. 38)
 Disconnect the Electrobrush from the
vacuum cleaner (Fig. 10).
 Place the Electrobrush upside down
on a level, clean surface.
 Use a pair of scissors to cut any
threads or hairs that have wound
themselves around the roller brush. To
guide the scissors, move along the
guide track on the roller brush.
en-CA
25