DragonTouch VISION 3 Manual De Usuario página 11

EN
Customizing Your Vision 3
Video Settings
When on the video settings screen, press the Down button to choose a setting from
the available options, then press the OK button to confirm your selection and
change the setting. To return to the preview screen, press the Mode button several
times and then press the OK button.
1. Video Resolution
4K 30FPS/2.7K 30FPS/1080P 60FPS/1080P 30FPS/720P 120FPS/720P 60FPS/720P
30FPS (Default setting: 4K 30FPS)
This camera is capable of recording video up to 4K30fps. The higher resolution, the
greater clarity and detail, thus the larger the file.
Note: Capturing high-resolution or high-fps videos in warm environments can cause
the camera to heat up and consume more power.
2. Recording Sound
On / Off (Default: On)
Turn "Recording Sound" on or off. With this setting disabled, the camera will record
video without audio.
3. Time-lapse
Off/0.5s/1s/2s/5s /10s/30s/60s (Default setting: Off)
Set the interval at which the camera captures frames of video. Once you're done
configuring, return to the preview screen. The camera will enter Time-lapse mode. In
this mode, the camera will capture frames at the preset interval and seamlessly
compile them into a short video.
Note: Time-lapse video is captured without audio.
4. Loop Recording
Off/1min /3 min /5 min (Default setting: Off)
Set the length of videos captured in Loop Recording mode. For instance, if you set
"Loop Recording" to "1 min", the camera will record and save videos every minute.
When the memory is full, the camera will automatically delete the earliest videos to
continue recording. Once you're done configuring, return to the preview screen. The
camera will enter Loop Recording mode.
9