DragonTouch VISION 3 Manual De Usuario página 15

EN
3. Format
Confirm / Cancel (Default setting: Cancel)
To keep your memory card in good condition, reformat it on a regular basis.
Reformatting erases all of your content, so be sure to offload your photos and
videos first.
4. Reset to Factory
Confirm / Cancel (Default setting: Cancel)
This option resets all settings to their default values.
5. Firmware Version
This option allows you to check the brand, model, and firmware version of your camera.
Connecting to the XDV App
You can control your camera to capture photos and videos using the phone app. To
do this, please download and install the XDV App on the App Store or Google Play
first. When your camera is connected to the app, you can control it to capture, or
change the camera's settings using your phone. You can also live preview, playback,
download, and edit videos via this app. Please follow the instructions below to
connect your camera to the app.
1. Turn on the camera, then press and hold the Wifi button to turn on Wifi. The
camera will enter Wifi mode and display the Wifi information.
2. Turn on your phone's Wifi to enter the Wifi settings page, find the Wifi SSID named
"Vision3_****" in the list and tap on it, then enter the password 1234567890 for
connection.
Warm tip: Once the camera Wifi is connected, it will give you a "No Internet
Connection" or "Weak Security" notice since your phone's 4G signal is blocked.
You can ignore it and continue the app connection.
3. Open the XDV app on your phone or tablet, and tap on the Wifi SSID again.
4. Your camera will be connected to the app in seconds.
Note: This camera does not support MacBook or iPad.
13