Vestfrost VLS 054A SDD Manual Tecnico página 21

Main functions
How to see the set point
1. Push and immediately release the SET button. The display will show the set point value.
2. Push and immediately release the SET button or wait for 5 seconds to display the probe
value again.
How to change the set point
1. Keep SET button pressed more than 2 seconds to change the set point value.
2. The value of the set point will be displayed and the "°C" or "°F" LED starts blinking.
3. To change the set point value push the UP or DOWN buttons.
4. To memorize the new set point value push the SET button again or wait for 10 sec.
How to change a value
To change the parameter´s value operate as follows:
1. Enter the programming mode by pushing SET + DOWN for 3 sec. The "°C" or "°F" LED
start blinking.
2. Select the required parameter. Press the "SET" key to display its value
3. Use UP or DOWN to change its value.
4. Press SET to store the new value and move to the following parameter.
To exit: Press SET + UP or wait for 15 sec without pressing a key.
NOTE: Factory default set point for VLS 054/094/154 SDD = 3 °C
21
GB