Publicidad
Idiomas disponibles
Idiomas disponibles
replace bits when they become dull. Dull bits will
produce poor results and may overheat the drill.
4.
use a coating of light oil when drilling into metal to
help cool the bit, increase drilling action and extend
drill bit life.
WARNING:
or twisting the bit, or failure to maintain balance in
case of binding and breakthrough can result in serious
personal injury.
NOTE:
to drill more accurately and prevent the drill bit
from "walking", using an awl or other sharp tool to make a
small dent at the spot to drill will help.
CLEANING
avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
fluids, gasoline, petroleum-based products, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which may
result in serious personal injury.
this product is warranted free from defects in material and workmanship for 2 years after date of purchase. this limited
warranty does not cover normal wear and tear or damage from neglect or accident. the original purchaser is covered by
this warranty and it is not transferable. Prior to returning your tool to store location of purchase, please call our toll-free
help line for possible solutions.
THIS PRODUCT IS NOT WARRANTED IF USED FOR INDUSTRIAL OR COMMERCIAL PURPOSES.
ACCESSORIES INCLUDED IN THIS KIT ARE NOT COVERED BY THE 2 YEAR WARRANTY.
for questions about this or any other genesis™ Product, please call toll-free:
www.genesispowertools.com
or visit our web site:
APPLICATIONS
forcing a drill bit, bending
MAINTENANCE
Do not at any time let brake
TWO-YEAR WARRANTY
TOLL-FREE HELP LINE
©richpower industries, inc. All rights reserved
richpower industries, inc.
Printed in China, on recycled paper
GENERAL HAMMER DRILLING
• use the hammer mode for drilling and driving into
concrete and masonry.
• use a slow speed to avoid cracking the concrete or
masonry.
NOTE:
for best results, use masonry bits which are
designed for percussion usage.
electric tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the
fiberglass chips and grindings are highly abrasive to
bearings, brushes, commutators, etc. Consequently, we
do not recommended using this tool for extended work on
these types of materials. however, if you do work with any
of these materials, it is extremely important to clean the
tool using compressed air.
LUBRICATION
this tool is permanently lubricated at the factory and
requires no additional lubrication.
736 hampton road
williamston, sC 29697
ENGLISH
888-552-8665
.
9
Publicidad
