Taurus BOREAL SILENCE Instrucciones De Uso página 10

partial discharge of the stocked energy therefore affecting
longevity.
• Remove the cover of the battery compartment.
• Check that the plastic covering that protects the battery
has been removed (some batteries are sold with a
protective covering).
• Put the battery in its compartment, respecting the polarity.
• Replace the cover of the battery compartment.
• It is essential that the batteries should always be the
same kind and the same charge. Never mix alkaline
batteries with Carbon-Zinc ones and/or rechargeable
ones.
• Non-rechargeable batteries are not to be recharged.
• DO NOT charge rechargeable batteries while they are
still in the appliance as it may cause internal gas or heat
generation, resulting in an explosion or possibly a fire that
could cause serious injury or property damage.
• To preserve battery life, remove the batteries when it's not
being used, and is not expected to be used for extended
periods of time.
ASSEMBLING THE BASE
• Fit the base with the column and secure it with the base
screw provided. (Fig. 1).
• Couple the appliance to the base inserting the inner pipe
in it and fixing it by using the upper lock nut.
• Stand the appliance up again so as to check that the base
works properly.
ASSEMBLING THE GRILL AND THE PROPELLER
(FIG. 2).
• Remove the rear grill nut and the propeller nut from the
motor shaft if they are attached to it when removing the
appliance from its packaging.
• Fit the rear grill (E) on the motor housing (G), matching
their fitting points.
• Tight the grill nut (D) that attaches the grill, make sure of
a correct setting.
• Fit the propeller (C) On the motor shaft (F) fitting in its
right position.
• Tight the propeller nut (B) that attaches the propeller.
Make sure of a correct setting.
• Fit the front grill (A) front the rear grill (E). Fix the front
and rear grills turning around its fixing belt (P) and tight
the security screw by using a screwdriver.
• Check the correct rotation of the propeller.
INSTRUCTIONS FOR USE
BEFORE USE
• Make sure that all product's packaging has been
removed.
• Please read carefully the "Safety advice and warnings"
booklet before first use.
• Prepare the appliance according to the function you wish
to use:
USE
• Extend the supply cord completely before plugging it in.
• Connect the appliance to the mains.
• Guide the appliance to direct the flow of air in the desired
direction.
• Turn the appliance on, by using the ON/Speed Change
button.
• The Fan Working Indicator (5) comes on.
• Select the desired speed by pressing ON/Speed Change
button again.
FAN FUNCTION
• Select the desired ventilation speed.
• Select the desired mode of ventilation (d).
TIMER FUNCTION
• The appliance's operating time can be controlled. (1-12h)
• To program the operating time simply select it using the
(c) button on the remote control.
• Each time the button is pressed, an hour is added.
• The programmed time will appear on the display.
• Once the selected time has elapsed, the device will turn
off automatically.
OSCILLATION FUNCTION
• The oscillation function makes it possible to direct the flow
from the apparatus so that it automatically alternates over
a range of 75º.
• To activate this function, press the (b) button on the
control remote or (3) in the control panel.
• To deactivate this function, press one of these two buttons
again.
ROOM TEMPERATURE
• In standby mode or after 5 seconds without manipulation,
the fan will display the room temperature.