Haier HFR79F19EFGK Manual Del Usuario página 17

Ice-making function
1. Under unlocked state, press the button "B" (Ice-making function selector), the
buzzer rings once, the indicator "e" (Ice-making function) illuminates, and then
the Ice-making function will be turned on.
2. When the indicator "e" (Ice-making function) illuminates, press the button "B"
(Ice-making function selector), the buzzer rings once, the indicator "e" (Ice-
making function)goes off,and then theIce-making function will be turned off.
Fast Ice function
1. Under unlocked state press the button "C" (Fast Ice function selector), the
buzzer rings once, the indicator "f" (Fast Ice function) illuminates, then the Fast
Ice function will be turned on and the indicator "e" (Ice-making function) will also
illuminates.
2. When the indicator "f" (Fast Ice function) illuminates, press the button "C"
(Fast Ice function selector), the buzzer rings once, the indicator "f" (Fast Ice
function) goes off,and then the Fast Ice function will be turned off.
3. After the Fast Ice function is turned on, the refrigerator will automatically
turn off the function when it has lasted for about 8 hours. If you want to exit
manually, you can press the button "C" (Fast Ice function selector) to turn it off.
NOTICE
1. If the Ice-making function is turned off, the Fast Ice will also turned off.
2. If the ice storage box is full, ice making stops.
3. The ice machine usually does not start making ice until approximately 48 hours
after the initial installation of the equipment.
4. If ice cubes are stored in the ice storage box for too long, they may stick together
and not separate easily. In this case, the ice storage box should be emptied and new
ice should be made.
Auto Set function
1. When the display screen is unlocked, press the button "J" (Auto Set function
selector), the buzzer rings once, the indicator "m" (Auto Set function)
illuminates, and then the Auto Set function will be turned on.
2. When the indicator "m" (Auto Set function) illuminates, press the button "J"
(Auto Set function selector), the buzzer rings once, the indicator"m" (Auto Set
function)goes off,and then the Auto Set function will be turned off.
Use
EN
17