Dreame Z30 Manual De Usuario página 19

Cleaning the Motorized Mini-
Brush
1. Use a coin as illustrated to rotate the
lock counterclockwise until you hear a
click. After unlocking the motorized mini-
brush, remove the brush roller.
Fig. F-13
2. Rinse and clean the brush roller. Stand
the brush roller upright in a well-ventilated
area for at least 24 hours until it is fully dry.
Fig. F-14
3. Once the brush roller is dry, reinstall it by
following the disassembly steps in reverse.
Fig. F-15
Cleaning the Illumination Soft
Roller Brush
1. As shown in the picture, press the brush
roller release button to remove the roller
from the slot.
Fig. F-16
2. Separate the roller from the side cover.
Turn the small wheel release buttons
counterclockwise to remove the wheels.
Fig. F-17
3. Use scissors to cut off the hairs and
fibers that get stuck on the brush roller
and the wheels. Wipe the dust from the
notch and transparent cover with a dry
cloth or paper towel. Thoroughly dry
before use.
Fig. F-18
4. When it is dirty, rinse the brush roller
with clean water until it is clean. Then
stand the brush roller upright for at least
24 hours until it is fully dry.
Fig. F-19
Replacing the Battery Pack
The vacuum contains a removable
rechargeable lithium-ion battery pack
which has a limited number of recharge
cycles. After extended use, the battery
pack may no longer hold a charge. If this
happens, it means the battery pack has
reached the end of its life cycle and needs
to be replaced.
1. Press down the battery pack release
button and slide the battery pack to the
right, as illustrated, to remove it.
2. Install the new battery pack.
EN
7