Cembre BD300NDS Manual De Uso Y Mantenimiento página 11

2.9) Using the battery charger
Carefully follow the instructions in the battery charger user manual.
The approximate time to fully recharge a battery is about 40 minutes.
3. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance. Compliance with
the following points, should help to maintain its optimum performance:
3.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any residue,
especially close to pivots and moveable parts.
Do not use hydrocarbons to clean the rubber parts.
3.2) Routine maintenance 3.2) Routine maintenance
When the tool reaches the predetermined number of hours worked, it will signal via an audible
alarm that routine maintenance is recommended.
The tool will continue to work, however 15 sec. after use an alarm comprising 3 beeps
combined with illumination of the worklights (2) will signal that its return to CEMBRE for
service is recommended (Ref. to section 5).
3.3) Storage case
When not in use, the tool should be stored and transported in the plastic case supplied to prevent
damage. The case, type VAL-M/L1, is suitable for storing tool and accessories.
VAL-M/L1: Size 446x345xh145 mm (17.5x13.6x5.7 inches).
Weight 2,5 kg (5.5 lbs).
11