Cover Pools T3 Evo Manual Del Propietário página 16

ENGLISH
12.2 Manually Uncover the Pool
There are two ways to manually uncover the pool:
12.2.1 Roll Onto Tube by Hand
1. If applicable, remove the recessed lid.
2. Remove the bolt through the motor shaft.
Remove the four bolts holding the motor. Slide
the motor out from the clutch.
Figure 7. Removing Bolts
3. Slide the cover through the track toward the roller
for a few feet on both sides. Then roll it up by
turning the roller by hand.
4. Repeat this procedure until the cover is totally
retracted, keeping the roll as compact as
possible. To reduce any possible drag, loosen
both brakes completely.
12.2.2 Use 1/2" Drive on Square Hole
1. If applicable, remove the recessed lid.
2. Follow the procedure in section 12.1 to remove
the coupler bolt or clutch bolt and loosen the
brakes.
Page 16
Cover-Pools T3 Evo
®
3. The opposite end of the mechanism has a square
hole that is sized to accept a standard ½" drive
ratchet socket wrench.
Insert the wrench into the square hole. And then
use the wrench to turn the main tube in the same
direction that removes the cover from the pool.
Figure 8. Square Hole on Opposite End
WARNING
It is physically easier to remove the cover using the ratchet wrench
than it will be to close the cover. Closing the cover manually requires
two strong people. If you are using your cover as a safety barrier,
make sure you will be able to close the cover if needed, before you
open the cover.
Automatic Pool Cover | Owner's Manual
™