Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
1.
Enter 1583 or the current master PIN. The red
LED will flash as each button is pressed. If the
pin is accepted, the green LED will flash.
2.
Press 1 to enter programming mode. The red
and green LEDs will turn on.
3.
Press 1 to enter PIN change mode. The green
LED will flash
4.
Press 1, 2, 3, or 4 to select PIN memory
location. (The factory default master PIN in
memory location 1 can be changed.) The red
LED will flash.
NOTE: To exit PIN setup, press 0.
5.
Enter the new four-digit PIN. Both LEDs will
flash.
6.
Enter new pin again to confirm change.
– Red LED will flash
– Green LED will flash to indicate success.
– The system is ready for operation after a 20
second delay.
7.
Test the new PIN by following steps in section
4.3.
8.
Record new PIN in Table 1 for future reference.
Table 3. PIN Memory Location Record
Location #
1
2
3
4
13.4 Delete PIN(s)
NOTE: Press buttons within 20 seconds of each other or
programming access will time out.
NOTE: The master PIN in memory location 1 can be
changed but not deleted.
13.4.1 Delete One PIN
1.
Enter 1583 or the current master PIN. The red
LED will flash as each button is pressed. If the
pin is accepted, the green LED will flash.
Page 18
PIN
Cover-Pools
T3 Evo
®
2.
Press 1 to enter programming mode. The red
and green LEDs will turn on.
3.
Press 2 to enter PIN delete mode. The green
LED will flash.
NOTE: To exit PIN delete mode, press 0.
4.
Press 2, 3, or 4 to delete the PIN from that
memory location. The green LED will flash,
indicating success.
5.
Press (2, 3, or 4) again for confirmation. The
green LED will turn on after a brief delay,
indicating success. The system will be ready
after a 20 second delay and the green LED turns
off.
13.4.2 Delete All PINs
1.
Enter 1583 or the current master PIN. The red
LED will flash as each button is pressed. If the
pin is accepted, the green LED will flash.
2.
Press 1 to enter programming mode. The red
and green LEDs will turn on.
3.
Press 3 to enter all PIN delete mode. Both LEDs
will flash, indicating success.
NOTE: To exit PIN delete mode, press 0.
4.
Enter the master PIN to verify deletion. The
green LED will turn on after a brief delay,
indicating success. The system will be ready
after a 20 second delay and the green LED turns
off.
Automatic Pool Cover | Owner's Manual
™
Publicidad
