Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION! Check with the bubble level (5) to ensure the multisensor is set up horizontally. The
bubble must be completely inside the red circle, otherwise the wind direction and speed, as well
as the amount of precipitation, may be measured inaccurately. If the bubble is close to the center
of the circle, but not completely inside it, and you cannot adjust the mounting pipe, you can place
small wood or heavy cardboard wedges between the sensor and the top of the mounting post to
achieve the desired result (this will require loosening the bolts and some experimentation).
Then, make sure the arrow still points due west and tighten the bolts.
Reset button and transmitter LED
If the multisensor is not transmitting data, perform a reset. Press and hold RESET for 3 seconds. The LED will
remain on while RESET is pressed and then return to normal operation (flashing every 16 seconds).
Recommendations for improving wireless connectivity
To avoid radio frequency interference, we recommend that you adhere to the following conditions.
•
Place the console several meters away from computer monitors and TVs.
•
If you have devices on the 433MHz frequency and are experiencing intermittent connectivity, please
unplug them to troubleshoot.
•
The maximum range of the device is 100m without, and 30m with obstacles.
•
The radio signal does not pass through metal. With metal siding, place the sensor and console so that
there is a window between them.
Table of materials and their effect on radio signal transmission loss
Material
Glass (untreated)
Plastic
Wood
Brick
Concrete
Metal
Initial display console setup
Once reset, the device will turn on all segments of the LCD display for 5 seconds, display device information
(frequency, FSK/ASK, EU/USA, version), and begin recording the external channel (approx. 3 minutes).
Display Console Button Functions
SET: enter setup mode.
ALARM: indication of upper and lower threshold values, alerts ON/OFF.
HISTORY: indication of archived data, return to main mode.
MIN/MAX: indication of minimum and maximum values.
RESET button
LED indicator
Radio signal transmission loss
5−15%
10−15%
10−40%
10−40%
40−80%
90−100%
10
Publicidad
