6 - Conversion for LP or NG Gas
EN
3. Remove the nozzle by turning 9-32" (7 mm) nut driver
counter clockwise.
4. Install the injectors supplied with this appliances in the
appropriate burner. The injectors have small number
stamped on the side, this number codes the orifice diameter
and its correct burner location (see figure of the paragraph
"Injectors position").
5. Turn clockwise to tighten (tighten to a torque of 15 to 20
inch-lbs)
IMPORTANT NOTE: On small oven reassemble the
DEDICATED bake burner provided with the LP conversion
KIT.
6. Replace all parts following the reverse order. Save the
injectors and burner removed from the appliances for
future use.
18
Replace injector on (oven grill burner)
1. Remove the door as described in the paragraph "Door
removal"
2. Remove the screws securing the grill burner and withdraw
the burner from the support.