MasterCool MCP59 Manual De Instalación Y Funcionamiento página 7

WATER CONNECTIONS
The cooler operates by water being pumped from the bottom pan
through a water distribution system to saturate cellulose media pads.
The water lines are snapped into plastic keepers along the inside of
the unit.
Water Pump
A self-contained water pump continuously circulates water through
black plastic lines to a distribution tray in the top of the cooler that
percolates water over the media.
1. The pump and water lines are shipped disconnected.
2. The overflow drain (ITEM G) is attached to the drain line and
should be pushed down to be flush with the end of the drain tube.
3. Push the other portion of water line onto the intake port on the pump.
Overflow Drain
4. Remove the nut on the end of the drain and insert the fitting
through the hole in the cooler bottom. Then tighten the nut on
the bottom of the cooler.
5. Make sure the rubber washer (installed inside reservoir) does
not twist while tightening, which could cause it to leak. DO
NOT OVER TIGHTEN.
6. If leakage occurs after reservoir is full, re-tighten the overflow
fitting until leaking stops.
7. A standard water hose can be attached to exterior portion of
the overflow drain fitting to
Float Connection
The float has been installed in bottom of the cooler with ferrule and
compression nut zipped tied to the float. Cut these free for use
(as described below) with water line installation. The float level is
factory set to maintain 2 inches of water in the reservoir. After in-
stallation is complete the float might need readjustment by slightly
bending the float arm.
Water Source Connection
Steady water supply is required for operation of the cooler. If taking
water from an external faucet, there are two options for attaching
water to the cooler.
Option 1:
If using a standard water hose to supply water:
1. Install the float and red gasket on the inside of the cooler,
securing them with the threaded jam nut on the outside of
the cooler.
2. On the exterior, screw the small nut inside the water hose
connector onto the threaded float valve port. Can use a
14mm wrench to tighten. DO NOT OVERTIGHTEN.
3. Screw a standard water hose into the connector. Verify wash-
er is in place.
4. Leave water spigot turned off until installation is complete.
Option 2:
A more permanent supply of water can be installed from an outside
water faucet by installing a sill-cock and 1/4" water line to supply
continuously to the cooler.
1. Install a sill-cock (locally available) onto the faucet.
2. Determine length of water line needed and install one end of
1/4" plastic or copper line on sill-cock and use the ferrule and
nut (zip-tied to the float for packing) to connect the water line
to the float valve attach point.
(
see illustrations at right)
1.
OVER-
FLOW
DRAIN
2.
DRAIN LINE FLUSH
WITH OVERFLOW
DRAIN
4.
5.
VIEW FROM TOP
TO WATER
DISTRIBUTION
OVERBOARD
DRAIN
INTERIOR
FLOAT VALVE GASKET
PLASTIC OR
COPPER LINE
TO COOLER
INTERIOR
6
3.
OVERFLOW
DRAIN
WASHER
COOLER
BOTTOM
6. VIEW FROM
NUT
BOTTOM
WATER PUMP
FLOAT VALVE
WATER LINE
ATTACH POINT
OPTION 1
EXTERIOR
WATER HOSE
JAM
CONNECTOR
NUT
WASHER
OPTION 2
SHUT OFF VALVE
SILL-COCK
STD. HOSE CONNECTION
EXTERIOR
COMPRESSION NUT
TO 1/4"
WATER LINE
FERRULE
LOCATION
OF DRAIN
TO
STANDARD
WATER
HOSE