Publicidad
Idiomas disponibles
Idiomas disponibles
7 THE CONTROL PANEL
On | Off Button
Turn the machine on by pressing the On | Off
button.
Cycles Button
Select a suitable cycle by pressing the Cycles
button. For the details of the cycles refer to
section Cycle Table.
Start / Pause Button
After choosing the cycle and options, press the
Start/Pause button to begin the cycle. The time
remaining will be shown in the Time Remaining
Indicator. The total time may change due to the
ambient temperature, water temperature, and
soil on the dishes. While the cycle is running,
pressing the Start/Pause button will pause the
cycle. It is best to avoid opening the door while
the dishwasher is running, but if it is necessary
to open the door, the cycle will pause when the
door is opened. If the door is closed within four
seconds after opening, the cycle will continue
automatically. If the door is opened for longer
than four seconds, the door must be closed
and the Start/Pause button must be pressed to
resume the cycle.
Options Button
Options can be selected by pressing the Options
button repeatedly. Sani Rinse, Accela Wash and
Extra Dry options can be selected by this button.
Half Load /High Temp Button
This button is used to select Half Load and High
Temp options. With a single press to the Half
Load button, Half Load Top Rack or Half Load
Bottom Rack selections can be made.
High Temp option can be selected by pressing
this button during 3 seconds.
Delay Hours Button
The start time of the cycle can be delayed for
1-19 hours by pressing Delay Hours. When the
Delay Hours button is pressed, the display will
show "1h." The display will alternate between
the delay time and the cycle duration every two
seconds. The delay time will increase in one hour
increments with every push of thd Delay Hours
button. When the desired delay hours has been
set, press the Start/Pause button.
NOTE: If the dishwasher door is opened during
the delay period and closed within four seconds,
the dishwasher will resume counting down the
delay period. If the door is opened for more
than four seconds, the delay timer is paused. To
resume the delay timer, close the door and press
the Start/Pause button.
Preparing The Machine
1. Open the door of the dishwasher.
2. Place the dishes in accordance with instructions
in the user manual.
3. Make sure that the upper and lower spray
arms rotate freely.
4. Put adequate amount of detergent in the
detergent dispenser.
5. Check if the Rinse Aid indicator is on and add
rinse aid if needed.
Program Selection
1. Press the On | Off button to turn on
dishwasher.
2. Refer the "Cycles and Options Table" to
determine a washing cycle suitable of your
dishes.
3. Press Cycles button until the selected program
appears on the display.
Auxiliary Options
Washing cycles of dishwasher are designed to
obtain the best cleaning effect, considering the
type of the soil, soiling degree and properties
of the dishes to be washed. Auxiliary options
are provided in order to enable you to save
time, water and energy and to perform a more
USA - CAN - 21
Publicidad
