Beurer MG 55 Manual De Instrucciones página 10

Fire hazard
 WARNING
There is a risk of fire if the device is used incorrectly or if it is not
used according to these
operating instructions.
For this reason, the massage device must only be operated as fol-
lows:
• Never operate the massage device for longer than 15 minutes
(risk of overheating) and allow it to cool o for 15 minutes be-
fore using it again.
• Never leave the device unsupervised, particularly if children are
around.
• Never use the device under covers, such as blankets or pillows.
Handling
 CAUTION
Switch the device o and disconnect the power supply after every
use and before every cleaning.
• Make sure that all moving parts can move freely at all times.
• Make sure that no hair can get caught in the device.
• Avoid contact with sharp or pointed objects.
• Do not kink the cable.
• Make sure that the device is not too close to heat sources
such as ovens, radiators or direct sunlight.
5. APPLIANCE DESCRIPTION
The associated drawings are shown on page 3.
1
Massage head
3
On-O switch; control
(infinitely adjustable
massage intensity)
5
Interchangeable massage
attachments
6. USE
Make sure that the device is switched o before inserting the power
cable. Switch on the device by rotating the controller clockwise past
the detent.
Set the desired massage speed using the control.
The Heat function can be switched on using the "Heat" button.
Replace the massage attachments by rotating the attachment on
the product in an anti-clockwise direction and replacing. Fix the
newly positioned massage attachment in place by rotating it in a
clockwise direction. Guide the device with both hands to the area
of the body to be massaged. You can stand, sit or lie down and can
massage yourself or another person. The massage intensity can be
altered by pressing more or less firmly with the massage device. Do
not massage a certain site of the body for longer than 3 minutes and
then change to other area of the body.
6.1 Start-up
• Remove the packaging.
• Check the device, power supply and cables for damage.
• Connect the device to the mains power supply. The device
must be switched o .
• Route the cable safely so that there is no risk of anyone tripping
over it.
NOTICE
Do not use the massage device just before going to bed. The mas-
sage can also have a stimulating e ect and may cause di culties
in getting o to sleep.
2
Heat function
4
Heat button
Heat function
 WARNING
• The massage must be pleasant and relaxing at all times. Stop
the massage or change the position of the massage device if
you find it is painful or unpleasant.
• Do not jam or force any part of your body, in particular your
fingers, into the area of the massage head.
7. CARE AND STORAGE
Cleaning
First unplug the device and allow it to cool o . Then you can clean
it with a cloth which is no more than lightly moistened. You can also
use a mild detergent.
 WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must
never be allowed to enter into the device or accessories.
• Do not use the device again until it is completely dry.
Storage
Keep the massage device in a cool and dry place where it is out
of the reach of children. We recommend storing the device in its
original packaging.
8. IN THE EVENT OF PROBLEMS?
Problem Cause
Massage Appliance not con-
head does nected
not move. to the power supply.
Device does not
move.
Overheating pro-
tection
tripped.
9. DISPOSAL
 WARNUNG
For environmental reasons, do not dispose of the device in house-
hold waste at the end of its service life. Dispose of the
device at a suitable local collection or recycling point in
your country. Observe the local regulations for material
disposal. Dispose of the device in accordance with EC
Directive – WEEE (Waste Electrical and Electronic Equip-
ment). If you have any questions, please contact the local
authorities responsible for waste disposal. You can obtain the loca-
tion of collection points for old devices from the local or municipal
authorities, local waste disposal company or your dealer, for exam-
ple.
10. TECHNICAL SPECIFICATIONS
Disposal 220-240 V~; 50/60 Hz; 20 W
Dimensions ca. 43.5 x 9.5 x 9.5 cm
Weight ca. 1000 g
11. GUARANTEE/SERVICE
Further information on the warranty and warranty conditions can
be found in the warranty leaflet supplied.
10
Remedy
Connect the plug to the
mains supply and
switch on the appliance.
Switch on the appliance.
Disconnect device from
mains power, wait at
least 15 minutes, plug in
again and switch on.