Publicidad
Idiomas disponibles
Idiomas disponibles
SilverCrest SPWD 180 I1
•
The following values are displayed a few times in succession:
o Body fat percentage (16)
o Water percentage (18)
o Muscle percentage (17)
o Bone percentage (15)
o Recommended calorie intake per day (13)
8.3 Auto power off
The diagnostic scales have an automatic switch-off function (Auto Power Off function). After
displaying the measurement result, the diagnostic scales switch off automatically.
8.4 Replacing the batteries
Replace the batteries when they are empty. To replace the
lithium batteries CR2032, remove the cover of the battery
compartment (7) at the rear of the diagnostic scales by
inserting a finger into the recess of the battery compartment
(7). Then lift the battery compartment (7) cover upwards and
remove it.
To remove the batteries, push them down a bit (see the
direction of the arrow in the illustration). You can then remove
the batteries from the holder.
Then insert two new CR2032 lithium batteries. Always pay
attention to the polarity. This is indicated in the battery
compartment (7), and the + symbol on the CR2032 lithium
batteries must be visible, as shown in the adjoining illustration.
Next insert the battery compartment (7) cover back to its
original position. The diagnostic scales are now ready to use.
28 - English
Your input data are stored permanently and will not be lost when replacing
the batteries.
Publicidad
