Electrical Connections - baltur TBG 35 PN Manual De Instrucciones

ELECTRICAL CONNECTIONS

The monophase power supply line must have a switch with fuses.
For the electrical connections (line and thermostats), follow the
attached wiring diagram. To carry out the connection of the burner
to the power supply line proceed as follows:
1) Insert the 7 and 4 pole plugs for version "P", in the appropriate
sockets located below the electrical panel base as shown in
figure 1.
2) To reach the electrical components, loosen the two screws (1),
gently pull back the cover to detach it from the electrical panel
base (fig. 2) then lift it up.
3) Re-close the lid taking care to position the two hooks (4) cor-
rectly in their respective housing (fig. 3).
only qualified technicians may open the burner's electrical
!
panel.
9 / 22
0006081437_201403
E
N
G
L
I
S
H
Fig. 1
Fig. 2
Fig. 3