Merach MR-R14 Manual Del Usuario página 15

Water Injection and Management
1. Water injection
NOTE: When filling with water, use a dry cloth under the tank to prevent wetting floors and
carpets.
Steps:
① Remove the rubber plug at the top of the tank.
② Place a large bucket of water next to the rowing machine and insert the water pump spout
into the tank and the bottom hose into the tank.
③ Start the motorized water pump to start filling water, check the amount of water filled by
the water level scale on the side of the water tank.
Caution! Do not overfill!
④ Turn off the electric pump after filling water to the desired level.
⑤ Make sure that the tank plug has been re-plugged.
Note: If the local water quality is bad, it is recommended to use distilled water instead of tap
water.
2. Regular water replacement
Note: In case of water discoloration or bacterial or algal bloom, please change the water
source in time.
Rubber plug
Water
injection
012
EN