Publicidad
Idiomas disponibles
Idiomas disponibles
the local supply companies must be
taken into account.
• The competent technician must make
the electrical connection through a
plug, which must remain accessible.
If this is not possible or there is a
fixed
connection,
device must be available for all
poles, complying with the pertinent
requirements.
• Make sure that the furniture where
the oven is going to be placed can
withstand a temperature of 90ºC. The
fronts of the furniture in direct contact
must withstand 70ºC.
• Avoid installing the oven behind
decorative doors or furniture.
• No carpentry actions should be carried
out on the cabinet after installing the
oven. Remove any chips that may have
remained in the cavity.
• The furniture must be fixed to the wall,
at least with a conventional bracket.
• The power outlet must be behind the
oven, at the bottom (or outside the
mounting space).
• Try to wear protective gloves at all
times, you could be damaged by sharp
edges.
Fire hazard: Do not use long
network connection cables or
unauthorized adapters, it could
be dangerous.
• Try not to use multiple power outlets.
• You should only use certified extension
cables (with a minimum cross section
of 1.5 mm²), complying with national
safety requirements.
• If you need a longer connection cable,
you should contact the assistance
service.
• Never carry the appliance by holding it
by the handle
Prior to the installation process, be clear
about the following:
•
For the oven to work properly, the
kitchen structure must be suitable. The
kitchen unit panels next to the oven
a
disconnection
must be
•
made of heat-resistant material.
•
Make sure that the glues of units that
are made of plywood can withstand
temperatures of at least 120°C.
•
Plastics or adhesives that cannot
withstand such temperatures will melt
and deform the unit.
•
Once the oven has been housed inside
the hole, the electrical parts must be
completely insulated.
•
The oven has air vents through which
the air circulates.
page 8).
Installation process
• To begin the installation process, follow
the steps below:
• Check the space where the appliance
will be fitted. Take the measurements of
the oven as a reference and make sure
• that they are lower than the recess (see
pictures 03 and 04 on pages 5 and 6).
• Once the recess is ready, plug the oven
in and fit it into the recess, taking
special care not to bend or step on the
cable,
• the electrical connection should be as
shown in picture 05 on page 7.
• Once it is properly fitted, open the door
and fix the oven in position with the
help of a few screws (see picture 06 on
page 7). The oven is now
Electrical connection
All electrical connections must be made
by a licensed electrician. The connections
must be in accordance with national
regulations.
Make sure that the mains power supply
complies with the power indicated on the
product characteristics label.
USING THE APPLIANCE
Este aparato ha sido diseñado únicamente
para uso doméstico.
• Nunca use el aparato para otros
propósitos que no sean para los cuales
ha sido diseñado.
EN
(see picture 09 on
installed.
33
Publicidad
