Publicidad
Idiomas disponibles
Idiomas disponibles
of the control panel, as if moisture gets
inside it, there may be a risk of electric
shock.
• To clean the surfaces, use a damp
microfiber cloth or cloth, mild detergent
and hot water. When finished, wipe dry
with a soft, dry cloth.
• Clean the gasket after each use, as it
could crack due to grease residue.
• Do not allow dirt to remain uncleaned
for a long time as it may become
impossible to remove.
• Some
spills
remains...) can create color changes in
the material. This does not affect the
operation of the device. Do not try to
clean these stains.
• If you use aggressive products or
brushes, the oven may lose its self-
cleaning
properties
includes this mode).
• For a more comfortable cleaning, we
recommend disassembling the oven as
much as possible (remove accessories,
guides...).
• Remove the door and remove the glass
for easier cleaning. Be careful, the door
can have a considerable weight.
To remove the door glass
See picture 09 on page 9
Note: Please note that the images are for
reference only and may differ from the
actual product.
Take extra care when handling
the door and glass. They may
break and cause injury.
•
Open the oven door to its widest position
and pull the hinges you will find (Fig. 1).
•
Twist the door at a set angle of 15° or 30°
depending on your model and carefully
pull it off and remove the door from the
oven (Fig. 2).
•
Position the door on a stable and flat
place and pull the glass slowly out
(depending on the model, you may or
may not have to remove some latches
(fruit
juices,
roast
(if
the
model
to remove the glass) (Fig. 3 and 4).
•
After removing the inner pane, the
remaining pane must be removed
according to Fig. 5.
•
Repeat the reverse process to install
them again
Oven gasket
The oven gasket may become dirty over
time. In this case, you can clean it with a
damp cloth. Never use harsh or abrasive
cleaning products for this procedure. If
the gasket is worn or torn, contact the
appliance supplier to replace it.
Oven bulb
Before replacing the oven bulb, make sure
that the product is completely switched off
and no power is supplied. The oven bulb
must have the following specifications
•
Heat resistance up to 300ºC,
•
Power ratings: 230V
•
Power: 25W
The bulb inside the oven must be replaced
as shown in picture 07 on page 8.
•
Turn the outer part of the body
counterclockwise to remove it.
•
Remove
the
counterclockwise or pulling it towards
you depending on the model.
•
Fit the new bulb.
•
Reinstall the outer part
TROUBLE SHOOTING
On many occasions you will be able to
solve the faults that appear in your device
yourself, using the Problems-Solutions
table that is presented in this manual (see
table 03 on page 12). Otherwise, call our
Customer Service.
If you detect a fault that cannot be repaired
by yourself and prevents the use of the
appliance, disconnect it from the mains
and from the electrical panel.
Any repair or replacement of
electrical
bulb
by
turning
wiring
must
EN
it
be
37
Publicidad
