CHARGING
Insert the CyberCapsule battery firstly.
Method 1:
Insert the Kress 60V battery and then press the on/
off switch, the charging will start. (See Fig. A1)
Method 2:
Press the on/off switch, the power indicator light
stays green and the CyberLite charger enters
standby mode. Insert the Kress 60V battery and then
the charging will start. (See Fig. A2)
A1
2
A2
3
STANDBY MODE
1) After removing Kress 60V battery, the charging
process will be terminated, and the CyberLite
charger will enter standby mode. During standby
mode, the power indicator light remains steadily
on, while the charge indicator light is not
illuminated. (See Fig. B)
NOTE: If the Kress 60V battery is inserted within
5 minutes, the standby mode is deactivated
and the charging will start. If not, the CyberLite
charger automatically turns off.
2) When the Kress 60V battery is fully charged, the
CyberLite charger will enter standby mode. If
there is no further action, the CyberLite charger
will automatically turn off 4 hours later.
1
3
1
2
B
2
POWER OFF
Method 1:
Press and hold the on/off switch for 2 seconds, the
CyberLite charger will power off.
Method 2:
Press the battery pack release button and remove
the CyberCapsule battery, the
automatically. (See Fig. C)
turn off
C
CHARGING INDICATOR
This charger is a ''smart charger'' that is designed to
provide you information on the status of your battery
charge. Indicator lights in the table below will show
the charging status.
If you receive a defective charge indicator light (red
on), insert a new battery to determine if the charger
is OK. If the new battery charges correctly, then the
original battery is defective and should be returned
to an authorized Kress Dealer. If the new battery
displays the same problem as the original battery,
have the charger tested at an authorized service
center.
NOTE: The charge indicator light only indicates the
status of the Kress 60V battery and not that of the
CyberCapsule battery.
1
CyberLite
charger will
1
2
EN
9