Makita JR1000FT Manual De Instrucciones página 5

Switch action
006234
CAUTION:
Before plugging in the tool, always check to see
•
that the switch lever actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch lever. Tool speed
is increased by increasing pressure on the switch lever.
Release the switch lever to stop.
Speed adjusting dial
2 3
006235
The maximum strokes per minute with the switch lever
being fully depressed can be adjusted just by turning the
speed adjusting dial.
Turn the speed adjusting dial clockwise for higher speed,
and counterclockwise for lower speed.
Lighting up the lamps
1
006236
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the lamp, pull the switch lever. Release the
switch lever to turn it off.
1. Switch lever
1
1. Speed adjusting
dial
2. Lower
3. Higher
1
1. Lamp
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Do not use thinner or gasoline to clean the lamp.
•
Such solvents may damage it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing the saw blade
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade and/or blade clamp. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious injury.
Do not touch the blade or the workpiece
•
immediately
extremely hot and could burn your skin.
Tighten the saw blade securely. Failure to do so
•
may cause a serious injury.
When you remove the saw blade, be careful not to
•
hurt your fingers with the top of the blade or the tips
of workpiece.
Use B type saw blade only. Never use other type
•
blade. Failure to do so may cause a serious injury.
To install the saw blade, push the holder cover to rotate
the blade clamp to the released position as shown in the
figure.
3
1
2
006227
Keeping that situation, insert the saw blade into the
blade clamp as far as the two protrusions of the blade
can not be seen.
5
after operation; they
4
1. Holder cover
2. Blade clamp
3. Fixed position
4. Released
position
may be