Operation - Dometic Skyview Powered/Chain Instrucciones De Montaje Y De Uso

Operation

Pos. Description
rd red
wh white
ye yellow
9.6 Connecting to an AP remote control (optional, only
powered version)
I
NOTE
The button for setting up the remote control is located as shown
(depending on the motor):
• BR leaflet: fig. b
• MP leaflet: fig. b
• CA leaflet: fig. b
➤ Refer to the AP remote control manual for further instructions.
10 Operation
!
CAUTION! Risk of injury
Only for boats and yachts: If the blind is in front of an open window,
then the blind should be stowed when driving at more than 10 knots or
in a sea state of more than moderate, as this can cause damage to the
blind. Parts that come loose may injure persons in the vicinity.
10.1 Operating the powered version
I
NOTE
The motors have thermal cut-out devices built-in in order to prevent the
motors over-heating for safety reasons. Prolonged, repeated use or
overloading the blind could trigger the cut-out. If this happens allow the
motor to cool for a few minutes.
Observe the following notes:
• Each blind can be stopped in any position.
• When operating the blind with an automation system, operation depends on the
programming of the controls.
14
Skyview
EN