Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Removing dust
➤ Dust the blind regularly with a dust rag, dust glove. Blow excess dust off of your
fabric using a can of compressed air or a hair dryer on a cool setting.
➤ Fully deploy the blind to clean the fabric.
➤ Fully stow the blind to clean around side tracks or guide wires.
Spot cleaning
➤ Spot-clean with a soft white cloth, moistened with warm water. Add a mild deter-
gent if needed (non-abrasive and with no additives).
➤ Blot gently to avoid creasing or damaging the fabric. Always leave the blind
deployed to dry thoroughly.
Cleaning windows
➤ Always ensure the blinds are fully stowed before cleaning windows. This will
prevent spoiling the blind fabric by splatter or sprays of water or detergent.
12
Troubleshooting
Fault
Guide wire tension too low
Guide wire too short
Guide wire broken
Motor not working
Guide wire or side track blind not running
smoothly
16
Solution
➤ See chapter "Fitting the guide wire ver-
sions" on page 12.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
➤ Check if wiring for voltage to the motor is
correct.
➤ If power supply is checked and the motor
is still faulty contact your distributor.
➤ If using the AP remote control refer to the
AP remote control manual.
➤ Check restraint positions and recess
dimensions.
Skyview
EN
Publicidad
