8
Operation
8.1
Inserting/removing the battery
Inserting the battery
1.
Slide the battery* into the battery mount (1) of the product. The battery* clicks into place audibly.
Removing the battery
1.
Press the battery* release button and pull the battery* out of the product's battery mount (1).
8.2
Switching on/off (fig. 3)
CAUTION
Do not look directly into the LED work lamp or the light source.
Note:
The light head (7) can be rotated 90° clockwise and 180° anti-clockwise (fig. 2).
The LED front light (4) can also be used as a torch for spot lighting.
1.
Unfold the product. The light head (7) can be raised or tilted in 6 steps.
2.
Press the on/off switch (2) to switch off the LED rod light (3).
3.
Press the on/off switch (2) again to switch the LED front light (4) on.
4.
To switch off the product, press the on/off switch (2) again.
8.3
Attaching the cordless work light
Note:
Check permanent durability of the product fastening. There is a danger of injury from the product falling.
1.
With the fold-out hook (6), the cordless work light can be attached to an object and used as a
pendant light.
2.
You can attach a strap to the fastening bar (8) to wear the cordless work light on your wrist.
8.4
Applying the belt clip (5)
1.
During work breaks, the product can be hooked onto the belt with the integrated belt clip (5).
2.
Screw the belt clip (5) with the screw (5a) to the right or left screw-on point on the product, as re-
quired. Use a Phillips screwdriver for this (not included in the scope of delivery).
9
Cleaning and maintenance
9.1
Cleaning
WARNING
Danger of injury
Switch off the product and remove the battery before any cleaning work.
1.
Wipe any dirt off the lens with a dry cloth. Be careful to avoid scratching the LED lamp as this
can severely reduce the light intensity.
2.
Do not use any cleaning products or solvents; they could attack the plastic parts of the product.
Make sure that no water can penetrate the product interior.
22 | GB
www.scheppach.com