UFESA BS Mystic Topaz Manual De Instrucciones página 17

personnel from the brand´s Official technical support service may carry out repairs or
procedures on the device.
B&B Trends, S.L. disclaims all liability for damages that may occur to people, animals or
objects, for the non-observance of these warnings.
ASSEMBLY INSTRUCTIONS
Cup lid (A): To attach the cup lid (A), align its flanges with the holes, press it down and
turn it counterclockwise. To remove it turn it clockwise and pull it out.
Lid (B): Insert the lid (B) into the tritan jar (C) by pressing it down. To remove it, pull the
two tabs upwards. The lid (B) must be closed securely in position, otherwise, the applian-
ce cannot be activated.
Tritan jar (C): Hold the tritan jar (C) with the handle on its right side, place it into the main
unit (G). To remove the tritan jar (C), repeat the operation in reverse.
INSTRUCTIONS FOR USE
Manual Blending
1. Place the appliance on a flat horizontal surface and make sure it is unplugged.
2. Pour in the ingredients. The tritan jar (C) contains different weight marks for easy
use. The amount of mixture should never exceed the maximum capacity as indicated
on the tritan jar (C). Note: Never use liquids hotter than 70ºC or never run the appliance
empty.
3. Place the lid (B) and cup lid (A) securely in position. Please refer to the "Assembly
Instructions" section above. Do not run the appliance without the lid (B) and cup lid (A)
attached.
4. Attach the tritan jar (C) onto the main unit (G). Make sure that the jar is attached se-
curely in position. Please refer to the "Assembly Instructions" section above.
5. Plug in the appliance. The standby button (H) led light will flash.
6. Press the standby button (H) and press the speed button (F5) to select the speed you
need from 1 to 9.
7. Press the time button (F4) to select the required time from 5 seconds to 6 minutes.
8. At the end of preparation, the appliance will stop automatically after the preset time
has elapsed. Unplug the appliance and wait until the blades come to a complete stop.
9. Remove the tritan jar (C) and take off the lid (B), then pour out the ingredients.
Note: The appliance must not be operated more than 6 minutes at each cycle. Allow
the appliance to cool down for 30 minutes before next operation cycle in case motor
overheats.
Pulse button
Press the pulse button (F6). The appliance will work at maximum speed until you relea-
se the button.
Blending with automatic programs
Proceed according to steps 1 to 5 in "Manual blending" section. Press the Menu button
(F7) repeatedly to select the desired program.
17