Canceling The Demo Mode; Preparing The Card Remote Commander; Setting The Clock; Detaching The Front Panel - Sony MEX-BT2950 Manual De Instrucciones

3
Rotate the control dial to select from
"50K/9K," "100K/10K" or "200K/10K,"
then press it.
Receivable frequency by selected frequency setup:
FM 50 kHz: 87.50 MHz, 87.55 MHz, 87.60 MHz...
FM 100 kHz: 87.5 MHz, 87.6 MHz, 87.7 MHz...
FM 200 kHz: 87.5 MHz, 87.7 MHz, 87.9 MHz...
MW 9 kHz: 531 kHz, 540 kHz, 549 kHz...
MW 10 kHz: 530 kHz, 540 kHz, 550 kHz...

Canceling the DEMO mode

You can cancel the demonstration display which
appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "DEMO"
appears, then press it.
3
Rotate the control dial to select
"DEMO-OFF," then press it.
The setting is complete.
4
Press (BACK).
The display returns to normal reception/play
mode.
Preparing the card remote
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 26.

Setting the clock

The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "CLOCK-
ADJ" appears, then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press (SEEK)
–/+.
4
After setting the minute, press the
select button.
The setup is complete and the clock starts.
To display the clock, press (DSPL). Press
(DSPL) again to return to the previous display.
Tip
You can set the clock automatically with the RDS
feature (page 16).

Detaching the front panel

You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press and hold (SOURCE/OFF).
The unit is turned off.
2
Press , then pull it off towards you.
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.

Attaching the front panel

Engage part A of the front panel with part B of
the unit, as illustrated, and push the left side into
position until it clicks.
Note
Do not put anything on the inner surface of the front
panel.
A
B
7