PRODUCT INSTALLATION
Installation and connection
1. This appliance is only intended for domestic use.
2. This oven is intended for built-in use only. It is not intended for counter-top use or for
use inside a cupboard.
3. Please observe the special installation instructions.
4. The appliance can be installed in a 60cm wide wallmounted cupboard.
5. The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket.
6. The mains voltage must correspond to the voltage specified on the rating plate.
7. The socket must be installed and connecting cable must only be replaced by a
qualified electrician. If the plug is no longer to accessible following installation, an all-
pole disconnecting device must be present on the installation side with a contact gap
of at least 3mm.
8. Adapters, multi-way strips and extension leads must not be used. Overloading can
EN
result in a risk of fire.
9. Don't use under the work surface and that it must not be subject to spillage from
containers onto surfaces under which the appliance is installed.
The accessible surface may
be hot during operation.
Installation Instruction
The following must be noted
Electrical connection
The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket. Only a qualified electrician who takes the appropriate regulations into
account may install the socket or replace the connecting cable. If the plug is no longer
accessible following installation, an all-pole isolating switch must be present on the
installation side with a contact gap of at least 3 mm. Contact protection must be ensured
by the installation.
Fitted units
The installation cabinet must not have a back panel behind the appliance. Minimum
installation height: 850 mm.
Ventilation slots and intakes must not be covered.
EN-14