Publicidad
Idiomas disponibles
Idiomas disponibles
similarly qualified person to pre-
vent hazards.
With the heated underblanket
switched on, never
– place objects on it (e.g. suitcases
or clothes baskets),
– place a heating source such
as a hot-water bottle, heating
pad or similar items on it. The
heated underblanket may other-
wise be damaged.
The electronic components inside
the control unit
whilst operating the heated un-
derblanket. Therefore never cover
the control unit
the heated underblanket during
operation. This poses a risk of
injuries and / or damage to the
heated underblanket.
Always observe the information
on start-up, cleaning and care,
and storage.
If you have additional questions
on using our products, please
contact our Customer Service
Department.
Safety system
Note: The heated underblanket is fitted with a
safety system. Its electronic sensor system prevents
the heated underblanket from overheating over its
full area by switching it off automatically in the event
of a fault. If the safety system switches the heated
20 GB/IE
will heat up
1
or place it onto
1
underblanket off automatically due to a fault, then
the function indicator
2
to illuminate, even if the heated underblanket is
switched on.
Under no circumstances should you connect the
defective heated underblanket to another switch
of the same type. This would also result in a
permanent shutdown by the safety system in
the switch.
Please note that, for safety reasons, the heated
underblanket must not be used in the event of
a fault and must be sent to the service centre
address given below.
Special characteristics
This heated underblanket has been provided with an
especially soft and hygienic soft nonwoven fabric.
The textiles used in this heated underblanket meet
the high human ecological safety requirements of
the Oeko-Tex Standard 100 as proven in tests at
the Hohenstein Research Institute.
Preparations for use
Placing the heated underblanket
Starting at the foot end, spread out the heated
underblanket (top, see Fig. B) over the mattress.
The plug-in connector
ket should be towards the head end (see Fig. C).
First connect the control unit
underblanket by plugging the two parts of the
plug-in connector
5
RISK OF DAMAGE TO THE
PRODUCT AND / OR OTHER
PROPERTY! Please be sure
– the plug-in connector
not get pinched on the bedframe.
– the cable does not get wedged between the
bedframe and the mattress.
– the cable does not get severely kinked.
Otherwise the plug-in connector
cable could be damaged.
on the control unit
ceases
1
on the heated underblan-
5
to the heated
1
together (see Fig. D).
and the cable do
5
and the
5
Publicidad
