Footrest Angle - Vermeiren Altitude Manual De Instrucciones

To return to sitting position
1. Hold the push handle tight and pull with your finger tilt lever (6).
2. Move the push handle slowly up. Release the tilt lever to block the position.

3.3.2 Footrest angle

The footrest lever (12) holds the gas spring of the push mechanism in position. As soon
as the footrest lever is pulled, the gas spring is released.
By pulling footrest lever (12) on the side of the chair
the footrest (9) will turn upward. By pushing the
footrest manually down while pulling the lever, it is
lowered again. Release the lever when the legs are at
a comfortable height.
3.3.3 Footrest length
The footrest (1) can be (dis)assembled without
removal of the calf rest according to the instructions
below.
In the same way the footrest length can be adjusted
(range 185 mm: step less).
CAUTION
When the footrest is adjusted to largest size, it will
touch the ground when the tilted seat is turned back to
sitting position. Make sure the footrest is turned to
smallest size before tilting the seat.
Disassemble
1. Loosen clamping lever (4): Pull it up, turn it clockwise to replace it to new position. Next,
push it down on the bolt and turning it anticlockwise to loosen the bolt.
2. Repeat this till the footrest support (1) is released. Now it can be adjusted or removed.
Assemble/adjustment
1. Guide the footrest support (1) into the leg-rest socket (2) behind the calf-rest plate (3).
2. Adjust length of the footrest-support and fasten lever (4), in clockwise direction.
3. Make sure that the clamping lever (4) is firmly secured.
Risk of damage
EN - 9
Altitude, Coraille
Using this chair
12
9
4
EN
2018-08
NL
3
2
1