M-Audio KEYSTATION MINI 32 MK3 Guia Del Usuario página 11

Modulation Rate
It is possible to alter the sensitivity of the Modulation button effects using the "Mod Rate" function.
This lets you adjust the ramp up time for effects assigned to the Modulation button. The range for
Modulation Rate is 0 - 127, with a default setting of 64. The lower the value, the slower the rate and vice
versa.
As an example, the following set of instructions and accompanying table of values explains how to use the
"Mod Rate" function when changing the ramp time from the default value of 64 to 127.
Value
0
64 [default]
126
127
To adjust the Modulation Rate:
1. Press the Edit button. The Edit button light will illuminate to full brightness.
2. Press the "Mod Rate" key (F, 4th white key from the left).
3. Press E (10th white key from the right) to enter "1."
4. Press F (9th white key from the right) to enter "2."
5. Press D (4th white key from the right) to enter "7."
If you have made an error while entering the numerical data value, you can press the "CANCEL" key (C,
first white key on the left) to exit Edit Mode without making any changes.
As an alternative to steps 3 through 5, you can use the "+" and "-" buttons to change the value.
6. Press the "ENTER." key (G, last white key on the right.)
7. Press the "Mod" button to hear change in the effect rate.
The Mod Rate value is retained when the keyboard is turned off.
To return the Modulation Rate to the default settings:
1. Press the Edit button. The Edit button light will illuminate to full brightness.
2. Press the "Mod Rate" key (F, 4th white key from the left).
3. Press the "DEFAULT" key (C, 8th white key from the left). The Edit light will dim to half brightness
indicating that programming is complete.
11
Rate
Ramp occurs slowly
Ramp occurs relatively quickly
Ramp occurs very quickly
No ramp. Only one value is sent – min. or max