Auto Code Search; Code Identification - Hama 00012306 Instrucciones De Uso

5.2.3 Select the device you want to control using
the device key (e.g. TV). A successful selection
is indicated by the LED with one ash follo-
wed by permanent light.
5.2.4 Press the "POWER" or the PROG+/PROG- key
to zap through the preloaded codes until the
device you want to control reacts.
5.2.5 Press MUTE(OK) to save the code and exit the
code search. The LED indicator turns off.
Note
► Internal memory limitations allow only up to
350 most common device codes to be pre-
loaded. Due to the extensive
different available A/V devices on the mar-
ket, it may be possible that only the most
common main functions are available. If so,
repeat steps 5.2.1 to 5.2.5 to nd a more
compatible code. No code may be available
for some special device models.

5.3 Auto Code Search

Auto Code Search uses the same preloaded codes
as the Manual Code Search (5.2) but your Universal
Remote Control scanns through the codes automa-
tically until the device you want to control shows
a reaction. This might be that the device you want
to control switches off (POWER key) or changes the
channel (P+/P- keys).
5.3.1 Turn on the device you want to control
5.3.2 Press the SETUP key until the LED indicator is
permanently lit.
5.3.3 Select the device you want to control using
the device key (e.g. TV). A successful selection
is indicated by the LED with one ash follo-
wed by permanent light.
5.3.4 Press the PROG+/PROG- keys or POWER to
start the Auto Code Search. The LED indicator
ashes once followed by permanent light.
The Universal Remote Control has a latency of
6 seconds before the rst scan starts.
4
► Scan Speed Settings can be set at either 1 or
5.3.5 The LED indicator con rms each single code
5.3.6 Press MUTE(OK) to save the code and exit the
number of
5.3.7 To stop the Auto Code Search during the scan
► When all codes are searched without suc-

5.4 Code Identification

The Code identi cation offers you the possibility, to
determine an already entered code.
5.4.1 Press the SETUP key until the LED indicator is
5.4.2 Select the device you want to control using
5.4.3 Press SETUP key. The LED indicator ashes
5.4.4 To nd the rst digit, press the numeric keys
5.4.5 Repeat step 5.4.4 for the second, third and
Note: Scan Speed Settings
3 seconds. The default setting for the scan
time per single code is 1 sec. If this feels un-
comfortable , you can switch to 3 sec. scan
time per single code. To switch between the
scan times, press PROG+ or PROG- during
the 6 sec. latency before Auto Code Search
starts scanning.
scan with a single ash.
code search. The LED indicator turns off.
process, press the EXIT key.
Note
cess, the Universal Remoote Control exits
Auto Code Search and returns to operational
mode automatically. Currently stored code
is not changed.
permanently lit.
the device key (e.g. TV). A successful selection
is indicated by the LED with one ash follo-
wed by permanent light.
once followed by permanent light.
from 0 to 9. The LED indicator ashes once
to indicate the rst digit of the 4-digit code
number.
fourth digit.